LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra5 LT, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Master Cylinder Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Power Booster Attaching Nuts
    GM1289933Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the master cylinder assembly with the new attaching nuts.

    Tighten:  Tighten the master cylinder attaching nuts to 18 N.m (13 lb ft)  .

    2. Fig 2: Disconnecting/Connecting Brake Lines
    GM1289922Courtesy of GENERAL MOTORS CORP.
  2. For vehicles with the ABS braking system, as shown, connect the brake lines to the cylinder body.
  3. For vehicles with the non-ABS braking system, connect the brake lines to the proportioning valves.

    Tighten:  Tighten the brake lines to 16 N.m (12 lb ft)  .

  4. For vehicles with the manual transaxle, connect the clip to the clutch hose connection to the master cylinder reservoir, if equipped.
    5. Fig 3: Identifying Reservoir Electrical Connector
    GM1289919Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector.
  6. Add brake fluid.
  7. Inspect for leaks and recheck the fluid level.
  8. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (ABS)  or Hydraulic Brake System Bleeding (Manual) .
scientia non olet · About LEMON Manuals