LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra5 LS, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Diagnostic Information and Procedures >> Brake Pad Inspection

Brake Pad Inspection

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Inspect the brake pads for wear.
  4. Measure the thickness.

    Specification: 

    • The minimum thickness of the inner or the outer front pad is 2 mm (0.08 in).
    • The minimum thickness of the inner or the outer rear pad is 2 mm (0.08 in).

  5. Install the brake pads in axle sets only.
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals