LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra LT, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Wheel Drive Shaft Outer Joint and Seal Replacement (Manual) >> Installation Procedure

Installation Procedure

    Fig 1: Spreading Snap Ring With J 8059
    GM1242026Courtesy of GENERAL MOTORS CORP.
  1. Install the seal onto the axle shaft.
  2. Spread the snap ring using the J 8059  and remove the outer joint from the axle shaft.
  3. Fill the joint seal with 110-130 g (3.9-4.6 oz) of the recommended grease. Repack the joint with 110-130 g (3.9-4.6 oz) of the recommended grease.
    4. Fig 2: View Of Large Seal Retaining Clamp With J 35566
    GM1242025Courtesy of GENERAL MOTORS CORP.
  4. Install a new large seal retaining clamp and a new small seal retaining clamp.
  5. Crimp the new small seal retaining clamp and the new large seal retaining clamp using the J 35566  (1).
  6. Install the drive axle shaft to the vehicle. Refer to Inner Axle Shaft Replacement - Front Drive Axle (Automatic)  or Inner Axle Shaft Replacement - Front Drive Axle (Manual) .
scientia non olet · About LEMON Manuals