LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra LT, Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Wheel Drive Shaft Inner Joint and Seal Replacement (Manual) >> Removal Procedure

Removal Procedure

    Fig 1: View Of Boot Seals And Clamps
    GM1242033Courtesy of GENERAL MOTORS CORP.
  1. Remove the large seal retaining clamp. Discard the clamp.
  2. Remove the small seal retaining clamp. Discard the clamp.
    3. Fig 2: View Of Shaft Retaining Ring With J 8059
    GM1242032Courtesy of GENERAL MOTORS CORP.
  3. Degrease the joint.
  4. Remove the shaft retaining ring using the J 8059  (1).
    5. Fig 3: View Of Axle Shaft And Joint Assembly
    GM1242031Courtesy of GENERAL MOTORS CORP.
  5. Remove the axle shaft from the joint assembly.
    6. CAUTION: The ball retainer is stacked in position and is not serviceable. Attempting to service the ball retainer could result in reduced vehicle performance and possible personal injury.
  6. Remove the seal from the joint assembly.
scientia non olet · About LEMON Manuals