Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 4: This step determines whether the EBCM is faulty.
- 6: This begins a search for a short to ground in the circuit between the ABS indicator lamp and the EBCM.
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Antilock Brake System Schematics Connector End View Reference: Antilock Brake System Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Inspect the electronic brake control module (EBCM) connector. Is it connected properly? |
Go to Step 4 | Go to Step 3 |
| 3 | Connect the EBCM connector. Did you find and correct the condition? |
Go to Step 9 | - |
| 4 |
|
Go to Step 5 | Go to Step 6 |
| 5 | Replace the EBCM. Did you complete the replacement? |
Go to Step 9 | - |
| 6 |
|
Go to Step 8 | Go to Step 7 |
| 7 | Repair the short to ground in circuit L-GN between connector C110 and the EBCM connector. Did you complete the repair? |
Go to Step 9 | - |
| 8 | Repair the short to ground in circuit L-GN between the instrument panel cluster (IPC) connector A13 and connector C110. Did you complete the repair? |
Go to Step 9 | - |
| 9 | Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Is the repair complete? |
System OK | Go to Step 2 |