LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra LT, Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Front Bumper Impact Bar Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Front Bumper Components
    GM1308620Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the front impact bar with the bolts.

    Tighten:  Tighten the front impact bar bolts to 39 N.m (29 lb ft)  .

  2. Install the front bumper energy absorber. Refer to Front Bumper Fascia Energy Absorber Replacement .
  3. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement .
  4. Connect the electrical connector.
scientia non olet · About LEMON Manuals