LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra LT, Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Front Bumper Fascia Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Upper Fascia Screws
    GM1308612Courtesy of GENERAL MOTORS CORP.
  1. Install the front bumper fascia.
  2. Install the upper fascia screws.
    3. Fig 2: View Of Lower Fascia Screws
    GM1308609Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the lower fascia screws and the bolts.

    Tighten:  Tighten the lower fascia screws to 2 N.m (18 lb in)  .

    4. Fig 3: Identifying Fender To Fascia Bolts
    GM1308608Courtesy of GENERAL MOTORS CORP.
  4. Install the fender-to-fascia bolts and the screws.

    Tighten

    • Tighten the fender-to-fascia bolts to 10 N.m (89 lb in)  .
    • Tighten the fender-to-fascia screws to 2 N.m (18 lb in)  .
  5. Install the headlamps and the fog lamps. Refer to Headlamp Replacement (Four Door/Wagon) or Headlamp Replacement (Hatchback) and Front Fog Lamp Replacement .
  6. Install the front wheel well splash shields. Refer to Wheelhouse Splash Shield Replacement .
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals