LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra LT, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Column >> Repair Instructions >> Steering Wheel Replacement (Without SIR) >> Removal Procedure

Removal Procedure

    Fig 1: Accessing Steering Wheel Horn Cap Screw
    GM1308134Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Rotate the steering wheel to allow access to the steering wheel horn cap screw. Remove the horn cap screw.
  3. Rotate the steering wheel to allow access to the other steering wheel horn cap screw. Remove the horn cap screw.
    4. Fig 2: Identifying Steering Wheel Horn Leads
    GM1308164Courtesy of GENERAL MOTORS CORP.
  4. Remove the steering wheel horn cap and disconnect the horn leads.
    5. Fig 3: Identifying Steering Wheel Nut And Retaining Clip
    GM1308166Courtesy of GENERAL MOTORS CORP.
  5. Remove the steering wheel nut and the retaining clip.
    6. Fig 4: View Of KM-210-A Steering Wheel Removal Tool
    GM1308216Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: In order to install the steering wheel correctly, match-mark the steering column shaft to the steering wheel.
  6. Remove the steering wheel using the KM-210-A  or the J 1859-A  and the J 36541-A  (1). See Special Tools .
  7. Unclip the contact ring from the steering wheel, if necessary.
scientia non olet · About LEMON Manuals