LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra LT, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Column >> Repair Instructions >> Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Remove the upper and the lower instrument trim panels.
    3. Fig 1: Identifying Steering Wheel Rotation Sensor Electrical Connector
    GM1308129Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the steering wheel rotation sensor electrical connector.
  4. Lower the steering column. Remove the steering column from the intermediate shaft in order to allow removal of the steering wheel rotation sensor. Refer to Steering Column Replacement .
    5. Fig 2: Identifying Steering Wheel Rotation Sensor And Retaining Screw
    GM1308132Courtesy of GENERAL MOTORS CORP.
  5. Remove the retaining screw from the steering wheel rotation sensor.
  6. Remove the steering wheel rotation sensor.
scientia non olet · About LEMON Manuals