LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra LT, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Seat Back Replacement - Rear Split Folding >> Installation Procedure

Installation Procedure

    Fig 1: View Of Rear Seatback Bolts And Hinges
    GM1308602Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the seatback to the hinges with the bolts.

    Tighten:  Tighten the rear seatback bolts to 25 N.m (18 lb ft)  .

  2. Raise and secure the rear seatbacks in the upright position.
scientia non olet · About LEMON Manuals