Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 1: Bulb test. Clip one end of a jumper wire to the negative battery terminal. Clip the other end of the jumper wire onto one end of the bulb. Take the free end of the bulb, the end without the jumper attached, and touch it to the positive battery terminal.
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| 1 |
|
- | Go to Step 3 | Go to Step 2 |
| 2 | Replace the bulb. Did you complete the replacement? |
- | System OK | - |
| 3 |
|
- | Go to Step 4 | Go to Step 5 |
| 4 |
|
- | System OK | - |
| 5 | Inspect fuse Ef19. Does the voltage at fuse Ef19 measure within the specified range? |
11-14 V | Go to Step 7 | Go to Step 6 |
| 6 | Repair the open power supply circuit for fuse Ef19. Did you complete the repair? |
- | System OK | - |
| 7 |
|
11-14 V | Go to Step 8 | Go to Step 9 |
| 8 | Repair the open circuit between fuse Ef19 and the luggage compartment lamp. Did you complete the repair? |
- | System OK | - |
| 9 |
|
11-14 V | Go to Step 11 | Go to Step 10 |
| 10 | Repair the open circuit between the luggage compartment lamp and the luggage compartment lamp switch. Did you complete the repair? |
- | System OK | - |
| 11 | Use an ohmmeter to measure the resistance between ground and the BK wire at the luggage compartment lamp switch connector, harness side. Is the resistance equal to the specified value? |
0 Ω | Go to Step 12 | Go to Step 13 |
| 12 | Replace the luggage compartment lamp switch. Did you complete the replacement? |
- | System OK | - |
| 13 | Repair the ground circuit for the interior courtesy lamp. Did you complete the repair? |
- | System OK | - |