Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 1: Bulb test. Clip one end of a jumper wire to the negative battery terminal. Clip the other end of the jumper wire onto one end of the bulb. Take the free end of the bulb, the end without the jumper attached, and touch it to the positive battery terminal.
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Interior Lights Schematics Interior Lights Dimming Schematics Connector End View Reference: Lighting Systems Connector End Views |
||||
| 1 |
|
- | Go to Step 3 | Go to Step 2 |
| 2 | Replace the bulb. Did you complete the replacement? |
- | System OK | - |
| 3 |
|
- | Go to Step 4 | Go to Step 5 |
| 4 |
|
- | System OK | - |
| 5 | Test fuse Ef19. Does the voltage at fuse Ef19 measure within the specified range? |
11-14 V | Go to Step 7 | Go to Step 6 |
| 6 | Repair the open power supply circuit for fuse Ef19. Did you complete the repair? |
- | System OK | - |
| 7 |
|
11-14 V | Go to Step 8 | Go to Step 9 |
| 8 |
|
0 Ω | Go to Step 10 | Go to Step 11 |
| 9 | Repair the open circuit between fuse Ef19 and the interior courtesy lamp terminal 1. Did you complete the repair? |
- | System OK | - |
| 10 | Replace the interior courtesy lamp switch assembly. Did you complete the replacement? |
- | System OK | - |
| 11 | Repair the ground circuit for the interior courtesy lamp. Did you complete the repair? |
- | System OK | - |