Turn Signal Switch Housing Replacement

Turn Signal Switch Housing Replacement

Removal Procedure




Caution: Refer to SIR Caution.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the tilt head components.
3. Remove the turn signal and multifunction switch assembly only.
4. Slide the turn signal switch housing off of the steering column shaft assembly.

Installation Procedure





Important: The switch mounting bracket must be pressed firmly against the steering column tilt head.

1. Slide the turn signal switch housing onto the steering column shaft assembly.
2. Install the turn signal and multifunction switch assembly only.
3. Install the tilt head components.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.