LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Express 2500 V8-4.8L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transmission Control Systems >> Sensors and Switches - Transmission and Drivetrain >> Sensors and Switches - A/T >> Overdrive Switch >> Service and Repair >> 4L60-E/4L65-E/4L70-E - Automatic Transmission

4L60-E/4L65-E/4L70-E - Automatic Transmission



Tow/Haul Switch Replacement

Removal Procedure




1. Remove the instrument panel trim plate bezel.
2. Disconnect the electrical connector from the tow/haul switch.
3. Push in clips (1) on both sides of the switch.
4. Push the switch rearward to remove the switch from the trim.

Installation Procedure




1. Install the switch into the trim plate bezel opening by pushing the switch in until the clip (1) snap into place.
2. Connect the electrical connector to the tow/haul switch.
3. Install the instrument panel trim plate bezel.

scientia non olet · About LEMON Manuals