Engine Front Crossmember Replacement (RWD)

Engine Front Crossmember Replacement (RWD)


Removal Procedure





1.Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

2.Disconnect the electrical wiring harness connectors from the engine crossmember.

3.Remove the engine crossmember mounting bolts.

4.Remove the engine crossmember.

Installation Procedure





1.Install the engine crossmember.

Notice:Refer to Fastener Notice .

2.Install the engine crossmember mounting bolts.

TightenTighten the bolts to 120 N �m (89 lb ft).

3.Connect the electrical wiring harness connectors to the engine crossmember.

4.Lower the vehicle.