Engine Front Crossmember Replacement (RWD)

Engine Front Crossmember Replacement (RWD)

Removal Procedure




1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical wiring harness connectors from the engine crossmember.
3. Remove the engine crossmember mounting bolts.
4. Remove the engine crossmember.

Installation Procedure




1. Install the engine crossmember.

Notice: Refer to Fastener Notice.

2. Install the engine crossmember mounting bolts.

Tighten the bolts to 120 N.m (89 lb ft).

3. Connect the electrical wiring harness connectors to the engine crossmember.
4. Lower the vehicle.