Air Inlet Grille Panel Replacement
Air Inlet Grille Panel Replacement
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications . |
|
| 1 | Cap, Wiper Arm (Qty: 2) |
| 2 | Nut, Wiper Arm (Qty: 2) Tighten: 25 N.m (18 lb ft) |
| 3 | Wiper Arm, Wiper Arm Assembly
IMPORTANT:
Use the J 39637
Wiper Arm Puller to remove the wiper arm from the wiper arm drive spindle. See Special Tools .
|
| 4 | Seal, Hood |
| 5 | Screw, Air Inlet Grille Panel (Qty: 2) Tighten: 3 N.m (27 lb in) |
| 6 | Panel Assembly, Air Inlet Grille Panel |