LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L80-E/4L85-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Vehicle Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Input & Output Speed Sensors
    GM686957Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the input speed sensor seal with automatic transmission fluid.
  2. Install the input speed sensor (1) and the bracket assembly.
    3. NOTE: Refer to Fastener Notice.
  3. Install the bolt.

    Tighten:  Tighten the bolt to 11 N.m (96 lb in).

  4. Connect the input speed sensor electrical connector.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals