LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L80-E/4L85-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Transmission Extension Housing Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing The Output Shaft Seal From The Extension Housing
    GM749709Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Place a drain pan under the vehicle.
  3. Remove the propeller shaft. Refer to One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement .
  4. Using the J 6125-1B  (1) and the J 23129  (2), remove the output shaft seal (3) from the extension housing (4).
  5. Inspect the case extension housing for damage. Replace the extension housing if necessary. Refer to Transmission Extension Housing Assembly Replacement .
scientia non olet · About LEMON Manuals