Removal Procedure
Courtesy of GENERAL MOTORS CORP.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle
.
- Remove the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
- Remove the rear servo assembly from the transmission case as follows:
- Cover bolts (6)
- Cover (5)
- Cover gasket (4)
- Bottom retaining clip (3)
- Servo piston (2)
- Outer ring oil seal (1)
- Inner ring oil seal (7)
- Accumulator piston (8)
- Piston seal (9)
- Washer (10)
- Servo spring (11)
- Servo spring retainer (12)
- Selective pin (13)
- Accumulator spring (14)