LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L80-E/4L85-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Reverse Servo Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Rear Servo Assembly
    GM512992Courtesy of GENERAL MOTORS CORP.
  1. Install the rear servo assembly to the transmission case as follows:
    • Accumulator spring (14)
    • Selective pin (13)
    • Servo spring retainer (12)
    • Servo spring (11)
    • Washer (10)
    • Piston seal (9)
    • Accumulator piston (8)
    • Inner ring oil seal (7)
    • Outer ring oil seal (1)
    • Servo piston (2)
    • Bottom retaining clip (3)
    • Cover gasket (4)
    • Cover (5)
    • Cover Bolt (6)
    2. NOTE: Refer to Fastener Notice.
  2. Install the cover bolts (61).

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft).

  3. Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
  4. Lower the vehicle.
  5. Fill the transmission to the proper level with DEXRON® VI transmission fluid. Refer to Transmission Fluid Check .
    6. IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset.
    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
  6. Reset the TAP values. Refer to Transmission Adaptive Functions .
scientia non olet · About LEMON Manuals