LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L80-E/4L85-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Manual Shift Shaft Seal Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Sliding New Selector Shaft Seal Over Selector Shaft
    GM659339Courtesy of GENERAL MOTORS CORP.
  1. Carefully slide a new selector shaft seal (1) over the selector shaft (2) with the wide face of the steel case facing outward. Position the seal so that it is starting to enter the seal bore.
  2. Obtain J 43909  and remove the inner sleeve so that the tool will slide over the selector shaft.
  3. Slide the J 43909  into position so that the end of the tool contacts the seal being installed. Use a mallet to strike the J 43909  and drive the new seal into the seal bore until it is seated at the bottom of the bore.
  4. Install the PNP Switch. Refer to Park/Neutral Position Switch Replacement .
scientia non olet · About LEMON Manuals