Overdrive Carrier Assembly Assemble

Tools Required 

J 36850  Transjel® Lubricant

Fig 1: Locating Overrun Clutch Housing Thrust Bearing Assembly
Courtesy of GENERAL MOTORS CORP.
1. Install the overrun clutch housing thrust bearing assembly (513) into the overdrive carrier assembly (514). Retain with J 36850  or equivalent.
Fig 2: View Of Overdrive Carrier Pinion Gear Components
Courtesy of GENERAL MOTORS CORP.
2. Install one overdrive carrier pinion gear (518) and its roller bearings (517) and thrust washers (515, 516), into the overdrive carrier assembly (514) at the location marked at disassembly.
3. Install the overdrive carrier pinion gear pin (519).
4. Repeat steps 2 and 3 until all 4 pinion gear assemblies are installed in their original locations.
Fig 3: Installing Overdrive Carrier Pinion Gear Pin Retainer
Courtesy of GENERAL MOTORS CORP.
5. Install the overdrive carrier pinion gear pin retainer (520) on the overdrive carrier assembly (514). Align the pinion gear pins with the retainer slots.
6. Install the overdrive carrier pinion gear pin retainer retaining ring (521) on the overdrive carrier assembly (514).