Component Testing
WARNING: This page is about a different variant/trim than selected.
- Remove the fuel filter from the DFCM housing.
- Remove the DFCM housing from the vehicle.
- Connect a DMM between the ignition 1 voltage circuit and the ground circuit of the fuel heater.
- Cool the thermostatic switch of the fuel heater with ice or refrigeration.
- Observe the DMM for continuity.
- If the thermostatic switch does not turn and complete the circuit when the temperature is between -8.4°C to +15.4°C (+16.9°F to +59.8°F) replace the DFCM housing.