Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
Check the Water in Fuel lamp for proper operation. Refer to Water-in-Fuel Lamp Always On .
- Disconnect the fuel heater harness connector from the fuel DFCM housing.
- Turn ON the ignition with the engine OFF.
- Probe the fuel heater ignition 1 voltage circuit with a test lamp connected to a good ground.
- If the test lamp did not illuminate repair the open or short to ground on the ignition 1 voltage circuit.
- Probe the fuel heater ground circuit at the DFCM housing with a test lamp connected to battery voltage.
- If the test lamp did not illuminate repair the open in the ground circuit.
- If all circuits test normal, test the fuel heater thermostatic switch for proper operation. Refer to Component Testing in this diagnostic.