Air Pressure Application
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Refer to Charge Air Cooler Caution
.
- Attach the gage/regulator assembly from the J 46091 to the quick disconnect fitting on the J-46091-15. See Special Tools .
- Connect the air supply to the air valve on the gage/regulator assembly.
- Open the air supply valve slowly, increasing the air pressure in 34-69 kPa (5-10 psi) increments while listening for air leaks.
- An air leak hissing sound at the EGR valve vent port is normal.
- For accurate readings you must allow approximately 30 seconds for the air pressure to stabilize.
- Continue increasing the air pressure until the air valve is fully open.
IMPORTANT: