LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of TP Sensor, IAC Valve & Components
    GM356448Courtesy of GENERAL MOTORS CORP.
  1. Install the TP sensor O-ring seal (7) on the TP sensor (6).
  2. Install the TP sensor on the throttle body with the throttle valve in the closed position. Make sure the TP sensor lever lines up with the TP sensor drive lever on the throttle shaft.
    NOTE: Refer to Fastener Notice .
  3. Install the TP sensor attaching screws (5).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    4. Fig 2: View Of TP Sensor & IAC Valve Electrical Connectors
    GM389028Courtesy of GENERAL MOTORS CORP.
  4. Connect the TP sensor electrical connector.
    5. Fig 3: View Of Generator
    GM309169Courtesy of GENERAL MOTORS CORP.
  5. Install the generator. Refer to Generator Replacement (4.8L, 5.3L, and 6.0L) .
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals