LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Powertrain Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Powertrain Control Module (PCM)
    GM1204499Courtesy of GENERAL MOTORS CORP.
  1. Install the PCM to the PCM mounting tray.
  2. Secure the spring latch to the PCM.
    3. NOTE: Refer to Fastener Notice .
  3. Connect the PCM connectors to the PCM.

    Tighten:  Tighten the PCM connector end fasteners to 8 N.m (71 lb in).

  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. If a new PCM is being installed, program the PCM. Refer to Control Module References .
scientia non olet · About LEMON Manuals