LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.
  1. Install the MAP sensor to the upper intake manifold.
    2. Fig 1: Intake Manifold MAP Sensor
    GM260159Courtesy of GENERAL MOTORS CORP.
  2. Connect the MAP sensor electrical connector.
  3. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals