LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Knock Sensors
    GM54612Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the KS.

    Tighten:  Torque the sensor to 20 N.m (15 lb ft).

    2. Fig 2: Knock Sensor Wiring Harness Assembly
    GM54608Courtesy of GENERAL MOTORS CORP.
  2. Install the KS wiring harness assembly.
  3. Install the intake manifold. Refer to Intake Manifold Replacement .
scientia non olet · About LEMON Manuals