LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Ignition Coils & Spark Plug Wires
    GM339300Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil to the bracket.
    2. Fig 2: View Of Ignition Coil Mounting Bolts
    GM344167Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the ignition coil mounting bolts.

    Tighten:  Tighten the ignition coil mounting bolts to 8 N.m (71 lb in).

    3. Fig 3: View of Ignition Coil Harness Connector
    GM339299Courtesy of GENERAL MOTORS CORP.
  3. Connect the ignition coil harness connector.
    4. Fig 4: View Of Spark Plug Wires At Ignition Coil
    GM344169Courtesy of GENERAL MOTORS CORP.
  4. Connect the spark plug wires at the ignition coils.
  5. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals