LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
    2. Fig 1: View Of EVAP Pipe Quick Connect Fitting
    GM344610Courtesy of GENERAL MOTORS CORP.
  2. Push the evaporative emission (EVAP) pipe quick connect fitting retainer inward.
    3. Fig 2: View Of EVAP Purge Solenoid Vent Tube
    GM372717Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP pipe (2) from the EVAP purge solenoid (1).
    4. Fig 3: View Of EVAP Purge Solenoid Bolt, Solenoid & Isolator
    GM389993Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the EVAP purge solenoid electrical connector.
  5. Remove the EVAP purge solenoid mount bolt (2).
  6. Remove the EVAP purge solenoid (3) and the insulator (1) from the engine.
scientia non olet · About LEMON Manuals