LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Purge Solenoid Bolt, Solenoid & Isolator
    GM389993Courtesy of GENERAL MOTORS CORP.
  1. Install the insulator (1) on the EVAP canister purge valve (3).
  2. Install the EVAP canister purge valve (3) to the engine.
    NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister purge valve mount bolt (2).

    Tighten:  Tighten the EVAP canister purge valve mount bolt to 10.5 N.m (93 lb in).

    4. Fig 2: View Of EVAP Purge Solenoid Vent Tube
    GM372717Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP pipe (2) to the EVAP canister purge valve (1).
  5. Connect the EVAP canister purge valve electrical connector.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals