LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Electronic Throttle Actuator Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Throttle Actuator Control (TAC) Module Nuts
    GM855736Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the TAC module.
  2. Install the TAC module nuts.

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  3. Fig 2: View Of TAC Module Electrical Connector
    GM871922Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (1).
  5. Install the red CPA retainer.
  6. Fig 3: I/P Wiring Harness Electrical Connector
    GM858196Courtesy of GENERAL MOTORS CORP.
  7. Connect the I/P harness electrical connector (2).
  8. Refer to Control Module References for programming and setup information.