LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
IMPORTANT: Perform the Crankshaft Position System Variation Learn  when the CKP sensor is removed or replaced.
    Fig 1: View Of Starter
    GM211621Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the starter. Refer to Starter Motor Replacement (4.8L, 5.3L, and 6.0L) .
    4. Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector
    GM56592Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the crankshaft position (CKP) sensor electrical connector.
    5. Fig 3: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  5. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
  6. Remove the CKP sensor retaining fastener.
  7. Remove the CKP sensor.
scientia non olet · About LEMON Manuals