LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the CKP sensor.
    NOTE: Refer to FASTENER NOTICE .
    2. Fig 1: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  2. Install the CKP sensor retaining fastener.

    Tighten:  Tighten the fastener to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector
    GM56592Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector.
    4. Fig 3: View Of Starter
    GM211621Courtesy of GENERAL MOTORS CORP.
  4. Install the starter. Refer to Starter Motor Replacement (4.8L, 5.3L, and 6.0L) .
  5. Lower the vehicle.
  6. Connect the negative battery cable.
  7. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals