LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the CMP sensor.
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  3. Connect the CMP sensor electrical connector.
  4. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals