LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Water Outlet Stud Ground Wire
    GM712012Courtesy of GENERAL MOTORS CORP.
  1. Remove the air intake duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  2. Disconnect the mass air flow/intake air temperature (MAF/IAT) sensor (5) connector.
  3. Loosen the clamp securing the MAF/IAT sensor to the air cleaner assembly.
  4. Remove the MAF/IAT sensor.
  5. Pull up on the air cleaner assembly (1) to release the retainers from the air cleaner adaptor (2).
scientia non olet · About LEMON Manuals