LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Accelerator Pedal Assembly
    GM871926Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to the FASTENER NOTICE .
  1. Install the accelerator pedal assembly.
  2. Install the accelerator pedal nuts.

    Tighten:  Tighten the nuts to 20 N.m (15 lb ft).

    3. Fig 2: View Of Accelerator Pedal Position Sensor Electrical Connector
    GM858238Courtesy of GENERAL MOTORS CORP.
  3. Connect the APP sensor electrical connector.
  4. Reposition the carpet.
  5. Connect a scan tool in order to test for proper throttle-opening and throttle-closing range.
  6. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
  7. Verify that the vehicle meets the following conditions:
    • The vehicle is not in a reduced engine power mode.
    • The ignition is ON.
    • The engine is OFF.
  8. Inspect the carpet fit under the accelerator pedal.
scientia non olet · About LEMON Manuals