LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 6.6L (LLY) - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying MAF/IAT Sensor
    GM1731292Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the MAF/IAT sensor TORX® screws.

    Tighten:  Tighten the screws to 8 N.m (70 lb in).

    3. Fig 2: Identifying MAF/IAT Sensor Electrical Connector
    GM1655957Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAF/IAT sensor electrical connector.
scientia non olet · About LEMON Manuals