LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 6.6L (LLY) - Introduction (2 Of 2)) >> Repair Instructions >> Glow Plug Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Glow Plugs
    GM1335554Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the glow plug(s).

    Tighten:  Tighten the plug to 18 N.m (13 lb ft).

  2. Install the harness to the glow plug(s).
  3. Install the glow plug harness nut(s).

    Tighten:  Tighten the nut to 1.7 N.m (15 lb in).

  4. Install the left front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  6. Install the engine splash shield. Refer to Wheelhouse Splash Shield Replacement .
  7. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals