LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 6.6L (LLY) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Filler Hose Replacement (Cab/Chassis) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Fill Pipe Clamp & Vent Pipe Clamp
    GM1228174Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the fuel and vent holes in the fuel tank.
  2. Install the fuel fill and vent hoses to the tank.
    NOTE: Refer to Fastener Notice .
  3. Tighten the fuel fill and vent hose clamps (1, 2) at the tank.

    Tighten:  Tighten the clamp to 2.5 N.m (22 lb in).

    4. Fig 2: View Of Fuel Feed And Pressure Balance Lines
    GM1228187Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel feed and pressure balance rear lines. Refer to Metal Collar Quick Connect Fitting Service .
scientia non olet · About LEMON Manuals