LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 6.6L (LLY) - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Crankshaft Position Sensor Electrical Connector
    GM1335470Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the upper fan shroud. Refer to Engine Coolant Fan Upper Shroud Replacement (6.6L) .
  4. Disconnect the crankshaft position (CKP) sensor electrical connector.
    5. Fig 2: View Of CKP Sensor & Bolt
    GM1336119Courtesy of GENERAL MOTORS CORP.
  5. Remove the CKP sensor bolt.
  6. Remove the CKP sensor.
  7. If necessary, remove the CKP sensor spacer bolts.
  8. If necessary, remove the CKP sensor spacer.
scientia non olet · About LEMON Manuals