LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 6.6L (LLY) - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Accelerator Pedal Assembly
    GM1848812Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to the FASTENER NOTICE .
  1. Install the accelerator pedal assembly.
  2. Install the accelerator pedal nuts.

    Tighten:  Tighten the nuts to 20 N.m (15 lb ft).

    3. Fig 2: View Of Accelerator Pedal Position Sensor Electrical Connector
    GM858238Courtesy of GENERAL MOTORS CORP.
  3. Connect the APP sensor electrical connector.
  4. Reposition the carpet.
  5. Install the CPA retainer.
  6. Connect a scan tool in order to test for proper throttle-opening and throttle-closing range.
  7. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle and a wide open throttle (WOT).
  8. Verify that the vehicle meets the following conditions:
    • The vehicle is not in a reduced engine power mode.
    • The ignition is ON.
    • The engine is OFF.
  9. Inspect the carpet fit under the accelerator pedal.
scientia non olet · About LEMON Manuals