LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (4 Of 4)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Valve Rocker Arm Cover Installation - Left Side

Valve Rocker Arm Cover Installation - Left Side

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • All gasket surfaces should be free of oil or other foreign material during assembly.
    • DO NOT use the valve rocker arm cover gasket again.
    • The valve rocker arm cover bolt grommets may be used again.
    • If the vapor vent grommet has been removed from the valve rocker arm cover, install a NEW vapor vent grommet during assembly.
  1. Install a NEW cover gasket (504) into the valve rocker arm cover.
    2. Fig 2: View Of Valve Rocker Arm Cover
    GM1277108Courtesy of GENERAL MOTORS CORP.
  2. Install the valve rocker arm cover onto the cylinder head.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the cover bolts with grommets.

    Tighten:  Tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).

    4. Fig 3: Identifying Ignition Coils
    GM824413Courtesy of GENERAL MOTORS CORP.
  4. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the bracket bolts.
  5. Install the ignition coils and bracket assembly and bolts.

    Tighten:  Tighten the ignition coil and bracket assembly bolts to 12 N.m (106 lb in).

scientia non olet · About LEMON Manuals