LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (3 Of 4)) >> Off-Vehicle Repair Instructions (2 Of 3) >> Valve Rocker Arm Cover Removal - Right Side

Valve Rocker Arm Cover Removal - Right Side

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Ignition Coil Bracket Studs From Rocker Arm Cover
    GM824414Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not remove the ignition coils from the valve rocker arm cover unless required.
  1. Remove the ignition coil bracket bolts from the rocker arm cover, if required.
  2. Remove the ignition coil and bracket assembly from the cover.
    3. Fig 2: Oil Fill Cap & Oil Fill Tube
    GM824416Courtesy of GENERAL MOTORS CORP.
  3. Remove the oil fill cap from the oil fill tube.
  4. Remove the oil fill tube.
    5. Fig 3: Valve Rocker Arm Cover Onto Cylinder Head
    GM824415Courtesy of GENERAL MOTORS CORP.
  5. Remove the valve rocker arm cover bolts.
  6. Remove the valve rocker arm cover.
    7. Fig 4: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS CORP.
  7. Remove the gasket (504) from the cover.
  8. Discard the gasket.

    The bolt grommets may be used again if not damaged.

scientia non olet · About LEMON Manuals