LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (3 Of 4)) >> Off-Vehicle Repair Instructions (2 Of 3) >> Cylinder Head Removal - Right Side

Cylinder Head Removal - Right Side

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Right Cylinder Head
    GM1424504Courtesy of GENERAL MOTORS CORP.
  1. Remove the spark plugs from the cylinder head.
    2. IMPORTANT: The cylinder head bolts can NOT be used again. Install NEW cylinder head bolts during assembly.
  2. Remove the cylinder head bolts.
    3. NOTE: After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.
  3. Remove the cylinder head.
    4. Fig 2: View Of Right Cylinder Head Gasket And Alignment Pins
    GM63170Courtesy of GENERAL MOTORS CORP.
  4. Remove the gasket.
  5. Discard the gasket.
  6. Discard the cylinder head bolts.
scientia non olet · About LEMON Manuals