LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (3 Of 4)) >> Off-Vehicle Repair Instructions (2 Of 3) >> Cylinder Boring and Honing >> Deglazing Procedure

Deglazing Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Deglazing Cylinder Bore
GM490757Courtesy of GENERAL MOTORS CORP.

Using a ball type or self centering honing tool, deglaze the cylinder bore lightly. Deglazing should be done only to remove any deposits that may have formed. Use a 240-grit stone of silicone carbide, or equivalent material, when preforming the deglazing procedure.

A 240-grit stone is preferred for final honing. If a 240-grit stone is not available, a 220-grit stone may be used as a substitute.

scientia non olet · About LEMON Manuals