LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (2 Of 4)) >> On-Vehicle REPARI Instructions >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: When reusing valve lifters, install the lifters to their original locations.
    Fig 1: View Of Valve Lifters & Lifter Guides
    GM63233Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the valve lifters and engine block valve lifter bores with clean engine oil.
  2. Insert the valve lifters into the lifter guides.

    Align the flat area on the top of the lifter with the flat area in the lifter guide bore. Push the lifter completely into the guide bore.

    3. Fig 2: View Of Valve Lifter Guide And Bolt
    GM63230Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the valve lifters and guide to the engine block.
  4. Install the valve lifter guide bolt (1).

    Tighten:  Tighten the valve lifter guide bolt (1) to 12 N.m (106 lb in).

  5. Install the cylinder head and gasket. Refer to Cylinder Head Replacement - Left Side  or Cylinder Head Replacement - Right Side .
scientia non olet · About LEMON Manuals