LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (2 Of 4)) >> On-Vehicle REPARI Instructions >> Oil Level Indicator and Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  2. Remove the retaining bolt for the coolant recovery reservoir and set the reservoir aside.
    3. Fig 1: View Of Oil Level Indicator Tube Bolt
    GM824412Courtesy of GENERAL MOTORS CORP.
  3. Remove the oil level indicator from the tube.
  4. Remove the oil level indicator tube bolt.
  5. Remove the oil level indicator tube from the engine block.
    6. IMPORTANT: The O-ring seal may be reused if not cut or damaged.
  6. Inspect the O-ring seal for cuts or damage.
  7. Remove the O-ring seal from the tube (if required).
scientia non olet · About LEMON Manuals